Skip to content 
7 steps to install LED Wall Mirror?
As we all know, 99% of bathroom mirrors on the market are mounted on the wall, but every time you hire someone to install it costs money and is inconvenient, if only you could install it yourself. Today we will show the easiest way to install LED Wall Mirror step by step.
Before install LED wall mirror, Make sure the wall to be installed is a load-bearing wall that can support the weight of the mirror. Acoustic panels, plasterboards and laminates cannot be perforated. Now let’s begin to install LED Wall Mirror.
1） Prepare the tools before installing the mirror
Table Ruler Pencil Drill Hammer Screwdriver
2) Open the mirror carton and take out the factory-placed screws.
3）Measure the distance between the hooks.
Use a tape ruler to measure the distance between the centres of the two hooks on the back of the mirror.
4）Set centre points on the wall.
Measure the width and height of the wall with a tape measure and mark the two centre points with a pencil.
5) Punching holes.
Use the prepared drill to punch holes at the marked centre points. Usually, the 6-8MM drill bit punches holes about 5CM wide.
6) Punch the expansion tube.
Use a hammer to drive the expansion tube into the location of the drilled hole. Then screw into the expansion pipe with a screwdriver, leaving about 5MM distance from the wall at the end.
7） Hook the hanging tabs on the back of the mirror to the screws.
That is finished install LED Wall mirror. Connect the wiring, touch the on/off button and enjoy your time!
6) Punch the expansion tube. 7)Hook the hanging tabs on the back to the screws.
After reading this article, you should know how to install LED Mirror. Doesn’t it feel particularly easy. Yes, smart bathroom mirrors are much easier to install than traditional bathroom mirrors, and a lady can even do it on her own.
Whether you are an LED Mirror wholesaler or retailer, We have very detailed installation instructions in the mirror’s cardboard box to solve your worries!
By the way, there are 2 connection methods of LED lighting.
Some people prefer to use a plug, which is just as simple as plugging it directly into a socket near the mirror. Conversely, other people don’t like plugs. Connect the factory reserved wires to the cord box and then control the mirror with the button on the mirror. The above 2 ways can be done in our factory, just make sure before ordering.
2 different connection methods of LED lighting
Important: To avoid the risk of electrocution, please turn off the electricity mains before commencing the installation.
Any further questions welcome to visit our Facebook, our mirror experts are happy to answer your questions.
